|
|
|

|
|
|

|
OmniServer Server Edition
The classic OmniServer program, the time tested and proven technology that has been delivering data from thousand of devices for over ten years. The OmniServer Server Edition provides
connectivity from your serial and TCP/IP devices to any OPC UA, OPC DA , DDE, and SuiteLink client. Licensed V2.7 Users - See Note prior to download.
 
|
|
Summary:
The standard by which all other configurable servers are measured, the OmniServer Server Edition utilizes an advanced configurable protocol development tool to deliver any Serial, LPT, or
Ethernet data over to any OPC UA, OPC DA, SuiteLink, or DDE client. Without the use of programming, and only using dialog boxes, you can describe your data stream to OmniServer and have it control the polling of the device
and the delivery of the data. There is never a need for expensive custom drivers - OmniServer gives you all the tools you need to develop your custom driver.
Features:
- Fully configurable protocol engine, configured via dialog boxes.
- Communicates with most any device over RS-232, RS-422, RS-485, LPT, or any of three Ethernet flavors (TCP, UDP, and TELNET).
- Delivers that data to any Windows program that can act as an OPC UA, OPC DA or DDE client. Also supports WonderWare's SuiteLink communications.
- The number of devices that can be connected is limited only by resources on your computer.
- The number of clients that can be connected is also limited only by the resources on your computer.
- ASCII and Binary data streams supported.
Requirements:
- Windows XP Professional SP3
- Windows 2003 Server SP2
- Windows Vista, SP1
- Windows 2008
- Windows 7
- Including 64-bit Versions
- Disk space: approx. 6mb
- CPU - anything sufficient enough to run an OS listed above
- A client program capable of communicating using OPC UA, OPC DA, DDE, or SuiteLink. This is very important, as OmniServer will not communicate
with any device until a client program communicates with it.
Licensing and Purchasing
- OmniServer Server Edition is licensed on a per-computer basis. You are not limited to the number of devices to which you may communicate, but any additional computers running OmniWedge
will need additional licenses.
- Click here for purchasing information.
|
|
|
|

|
|
|
 |
|
|
|
|
|
P: 1-888-665-3678 (US-Sales) or 704-849-2773 (Support & International), F: 704-849-6388 148A East Charles Street,
Matthews, North Carolina, USA 28105 Copyright Software Toolbox, Inc., 1996-2006, All Rights Reserved Worldwide.
|
|
|